What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 23.06.2025 00:16
Here is a simplified AC power diagram.
There are three different concepts here that are getting confused.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Ireland added to list of countries monitored by the U.S. for currency manipulation - Fortune
This is where the MOV conducts again, and dissipated the energy.
But it can get overloaded, and no longer works.
It also is a device that limits the change in current flow.
How do you dry your hair fast?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
The third is lightning and “how it gets conducted into a home.”
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
In schematic diagrams this is the symbol for a fuse:
New rabies cases detected in SLO County. How to avoid deadly disease - San Luis Obispo Tribune
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
It seems Mohan does not understand the difference between a comment and an Answer.
a photo is worth a thousand words.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Upvotes:
What are the most interesting use cases of Alibaba's Qwen model?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is where this question deviates from being a 'generic' question, and becomes more specific.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Children of slain Minnesota lawmaker Melissa Hortman: 'We are devastated' - ABC News
what exactly is a ‘surge’ protector?
These are simplified answers to the original question, and does not change anything I wrote above.
One
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This one hit behind the barn.
PSA: You Probably Don't Need To Be Weighed At The Doctor's Office - HuffPost
This is 'the assistant's answer'
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
One is “what exactly is in a ‘surge protector’ ? ”
Which new book genres have emerged in the past decade?
so, what happens?
He then describes the function of a fuse.
[image of Common-mode choke]
Will ChatGPT make Quora obsolete?
First Sentence:
[old diagram got deleted by accident]
Edit 2024–10.
Should India conduct another air strike to attack Pakistan over the Pahalgam attack?
Because the load is inductive, the current lags the voltage.(by a bit).
At least they know the answer if they wanted it.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
A fuse is a non-resetable over current circuit protector.
How do I straighten my hair without flat iron?
The other is “what does a “fuse” do?”
What does a fuse do?
But… the neutral is now “floating” because of the 1 ohm resistance.
How much higher are McDonald's prices going to go?
The bolt then partially travels down the line to your home.
nine
2024–10–14 [Omar Gharbi Omar Gharbi ]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–16 [ OO OLAOYE OYEBODE ]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
A circuit breaker is similar, but is resettable.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
An AC voltage/ current source, and an ac inductive load.
For this case there are devices called Metal oxide varistors (MOV).
I post the exact comment here.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
He then asserts :
There are two important concepts here.
the problem then depends on "how fast does the fuse operate?".
What is lightning?
but I think this circuit , shows a few more pieces.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–10[John johnson John Johnson ]
These devices are installed between the “hot” and “neutral” and protective ground.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
but this device (an Inductor) … impedes the rapid changes in the current.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
He then describes Rainy Season and Lightning.
This device then solves the entire problem.
eight
This is the picture of an electronic coil of wire wound around a core of magnetic material.
So, the voltage could go up to 500 volts, and the fuse will not open up.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
(Dc diagram shown, AC is similar).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Barnstars:
Now when you have a certain ac resistance, then a current flows in a loop.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.